Shadow - Wolf Warrior v2.0 (single piece Action Figure)

This is an action figure very easy to print, its pre-assambled. All you need to do is just need to slice and print.
important to print with character laying down on his back.

I added other files for Resin and for FDM printers

(Filament Printers). Its the same character but with a fist.

you can use Act BW V4.5 & ACT BW V6 15cm Resin for Resin printers.
And for FDM printers use ACT BW V6 FDM 15cm

The action figure painted in black is in resin, the 4.5 verion with open hands. The one with fist is the version 6.0 resin

The white action figure is the filament action figure.

I tested the files with both resin and filament printer and they work perfect.

Resin:
I used the anycubic m3 with elegoo water washable resin
character laying down important
with supports
when print is ready leave soaking in water/alcohol for at least 4 hours so you can easily remove supports without damaging the print.

FDM:
I used the Creality Ender s1 plus, in my opinion the ender in the most accurate and reliable printer i ever used.

for better detail on character i used the 1.6 layer height(recomended).

Layer Height: 1.6
wall thickness: (minimum for endurance) 1.2mm
infill: i used 20%
speed: 45 mm/s
infill speed: 75mm/s
support overhang angle: between 45-65 (i used 65)
support desnity: from 1 - 12 ( i used 8 on my ender, so it will be easier to remove supports without damaging print)