Wanted something a bit more portable than the big single piece grips so I decided to try making a smaller one. This relies on a tiny peg that locks in one of the bottom screw holes on the joycon. You slide the grip in from the bottom until you feel the peg locking in. To take it off you push on the tab at the top and it pops right off.
I left a bit of wiggle room to put some strips of electrical tape to try to avoid scratching the joycons. I prefer that over making it really snug and scratch everything.
Work in progress, your mileage may vary.
Printed at 0.2mm, 2 perimeters, 5% infill.
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!