Skip to content

Motor Boat RC enlarged (experimental)

Creation quality: 5.0/5 (1 vote)
Evaluation of members on the printability, utility, level of detail, etc.

3D model description

At first I tried a 35 mm surface propeller which I got from a friend. This Propeller is more effective than my printed propeller. It needs less motor speed and was hardly to control because it pushes strong even with little throttle. So later I preferred the printed propeller. It is not so wild and makes more noise due to the higher motor speed ;-).
With increasing speed, the bow shoots up and throws a large bow wave which easily can splash water into the boat. To hold the bow low it was necessary to shift the weight forward. In the end even as much as possible.

Sorry for the bad video quality.
I uploaded it twice with different size but it doesn't make any difference. Partly it is highly compressed.

BTW, the ducks were not impressed at all...

3D printing settings

The best is, if you print it with spiral vase methode. Then you will get a neat surface without any noses from layer change.
The hull is 3.0 mm thick.
I printed with layer hight: 0.3 mm and width: 0.6 mm.
Anyway, you have to print it hollow with one perimeter otherwise it will not fit inside the interface part.

The interfaces are supposed to put them fifty-fifty in the gap of each hull part. In this way the the hull parts are aligned and easy to glue.
Before gluing you should mask the edges of the hulls with tape to keep them clean from glue.

It is designed for the Roxxy BL-Outrunner
Driving shaft:
3 mm rod 130 mm long with 11 mm M3 thread on one end.

3 heat shrink tubes, one into each other, both about 50 mm long.
I fastened the second one with rubber band to the motor shaft before shrinking the bigger one upon it. It is not necessary on the other side because of the longer contact surface.

Surface Propeller
This propeller needs an adapter from M4 to M3. Additional it had to be shortened to fit between the rudder and the stern.

Rudder Mount
The rudder mount now is 2.5 mm longer.

3D printer file information

  • 3D design format: STL Folder details Close
    • motor_boat_extension_100.stl
    • motorboat_interface_aft.stl
    • motorboat_interface_bow.stl
    • rudder_mount_4.4_plus_2.5.stl

    Learn more about the formats

  • Last update: 2018-06-27 at 11:17
  • Publication date: 2015-08-18 at 13:48





Designs 67
Downloads 14.3k
Followers 210

I am constructing engineer for powerplants. Designing was allways my passion and I am glad, now as a pensioner, to have interesting challenges again.
I want to give thanks to the

Issue with this design? Report a problem

Collection associated with this 3D model

Best 3D printer files of the Game category

Best sellers of the category Game

Add a comment

Would you like to support Cults?

You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:

  • ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.

  • AFFILIATION: Make your purchases online by clicking on our affiliate links here Amazon.

  • DONATE: If you want, you can make a donation via PayPal.

  • WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!