Mospeada MaxLab Cyclone

Inspired by the Robotech saga Mospeada ... MaxLab Cyclone!
I hope you like it, I tried to remain as faithful as possible to the original model, but to make it compatible with 3D printing, I had to make compromises.
They are practically two models:
the pilot, 19 cm tall (highly expressive and poseable)
the motorcycle, 19 cm long (fully transformable without removing or adding any parts).
Several small pieces are assembled WITHOUT screws. just a little glue and the usual pins, which I get from the pla 1.75 filament.
You can print it bigger, as long as you find the right size pins.
As you can see from the photos, the models have just been completed, they have not undergone any post-production intervention. They still present fragments of support here and there.
the model is complete with a pdf assembly manual, and a video showing the details of the transformation

Here you can see the video of the transformation:

https://www.facebook.com/MaxLabToys/videos/793936431371605/

Here you can see the video of the assembly manual:

https://www.facebook.com/MaxLabToys/videos/817580389013222/

follow me on Facebook:

https://www.facebook.com/MaxLabToys/?modal=admin_todo_tour

Pla Plus

Layer: 0.1 or 0.2
Support: everywhere
infill: 50/80%