Mario inspired desktop organizer... Pen holder Or Planter!

NOTE: COPYRIGHT PA1© - PERSONNAL USE ONLY. SUBSCRIBE TO MY PATREON TO GET ALL MY FILES FOR FREE, PLUS EXCLUSIVE MODELS AND A COMMERCIAL LICENSE TO SELL YOUR PRINTS. LINK TO PATREON :

https://www.patreon.com/PA1_MAKER

A nice desktop organizer, with a small drawer for sd cards and accessories, paper clips, push pins or whatever you like! The card section can hold 5 SD cards and 6 MicroSD.

If you don't wanna use the card holder, simply remove it and you'll have a second compartment to store whatever you like.

It can also be used as a nice planter (both version of pipe included). You can scale down or up the length of the pipe as you like (scale in Z axis in the slicer) and you can scale the whole assembly to fit any plant size, or any other needs.

-Everything is support free. No supports at all.
-All parts already place in the right orientation for printing.

There's no exploded view with the files, but the instructions are pretty straight forward.:

-All the parts are glued together, except for the drawer inside the base.

-The quantities required are indicated in the name of the files, and the only thing i may have to say regarding the assembly is to be careful to correctly place the tiles around the drawer.

You have one special tile between every two brick tiles. You have in total 4 brick tiles, 2 question mark tiles and 2 solid brick tiles. Start from left corner of the drawer, and glue them in place from left to right , in a counterclockwise pattern. That's what i did.

For the tiles, its a simple color change at the corresponding layer.

Question marks: Start with yellow, change for white

Bricks: Start with black, change for dark red

Solid bricks: Start with black, change for grey.

If you are not familiar with color changes, send me a message and i will explain it to you with pleasure!

If you have any other questions, again, send me a message!

Have fun! Keep printing!