Letters Alphas

Updated 9/29/21:

Following a big mistake detected by hashtag SEBASTIENORFILA, I added the correct version of the "a" that was upside down!!!!

So you can download the file "a_bon sens _ good one", or else in your slicer you can use the mirror function of the original a to get the right letter.

Sorry again for this mistake, I reassure you, my son gave me as punishment to fill 10 pages of "a" :)!

I created these letters for my son who is learning to read and discovered this method at school: https://planetedesalphas.com/methode/

There are all 26 letters of the alphabet as well as "é" and "ch"

• Printed on Dagoma DiscoUltimate

• PLA Filament

• Resolution: 0.2mm

• No support except for the W (for the rails)

• The letters are small, I suggest you print them at 200% in height and width. For the thickness you can leave 100% to save time and material, but be careful with large letters that don't stand up well (for that aim for 120-150% instead).

• About 15 to 40min per letter depending on the letters