Spin the propeller in your hands to lever the propellers into visually attractive positions!
Propellers are numbered for easy assembly.
Best works printed from PET
Layer height 0.2mm
Architecture Computational Designer @ AECOM | Creative Hybride [3D Artist, Content Creator, Videomaker] @ PRUSA RESEARCH
✎ I am a ❝CREATIVE HYBRID❞ based in London | always opened to challenges.
● ARCHITECTURE
● 3D DESIGN & 3D PRINT
● MOTION PICTURE
● CONSULTING & KNOWLEDGE PASS
➜ Start a collaboration
https://modelphase.com/
➜ Visit the portfolio:
http://www.dominikcisar.cz/
I printed this and all the numbers on B didn't print and some of the numbers on A are unreadable
Amazing :)
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
AFFILIATION: Make your purchases online by clicking on our affiliate links here Amazon, Gearbest or Aliexpress.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!
Don't even attempt this with PLA. The tolerances on the pins and slots is way too tight, impossible to print or even clean up after the fact without spending hours post-print. If this were on Thingiverse, the #Makes would likely be zero. The notes say this works best with PET, but maybe should say it works only with PET. You'll need zero "first layer squish" or "elephant foot" for this to work, or the pins don't fit the slots at all. I'd recommend slicing away all but two of the blades in TinkerCad to be able to test-print two blades over and over until you get something that works, if that's even possible. I'll retry with PET and update later.