fit-in puzzle

A fit-in puzzle model is presented ,where you try to perfectly fit all the 10 pieces of the puzzle into the board , enjoy !

• Standard quality (Layer height = 0.2 mm)
• No support or Built plate adhesion is needed (I know you like to hear that :) )
• I like to use ZigZag pattern for my prints , you can choose your favorite

Some unnecessarily changes :

• Infill density = 10 %
• Wall thickness = 1 mm

You can leave these values as default ,
but I change them to decrease the printing time without effecting the quality of the print

• Print time: board : 2 h and 18 min the 10 pieces all together : 2 h 20 min (I solve it in "1 min and 44 sec" and "3 min 13 sec " )