Running Pikachu

This running Pikachu is a funny little desk toy. While the crank is being turned, Pikachu simulates a realistic running motion.

All that is required for assembly is printed, so aside from PLA, there are no extra parts needed.

The assembly is pretty straight forward and takes only about 5 minutes, since a lot of the moving parts are print-in-place and therefore are already assembled.
An assembly video guide is included in the download.

Have fun printing and building your own Pikachu :-)

• the parts already have the correct printing orientation, when loaded into the slicer
• Use supports for the following parts: "Head" & "Legs"
• recommended nozzle diameter 0.4 - 0.6mm (both were tested)
• recommended maximum layer height: 0.3mm
• i used 3 perimeters and 15% infill