RC 720mm span F-35A Lightning II/ Stealth Joint Strike Fighter LW-PLA (Flyable)

This is a 3D printed RC model rendition of the F-35A Lighting II Stealth/ Joint Strike Fighter, for hobbyist.

It is intended to be printed in LW-PLA (Colorfabb, 3DLabprint, eSun eLW-PLA etc.) and has flown successfully.

Specifications:
-CENTER OF GRAVITY: 70mm from wing leading edge joint. Coincides with front edges of launch grip cutouts
-Span: 720mm
-Length: 1023mm
-AUW: 1320g
-Propulsion: 64mm EDF 4S (tested) or 6S
-Battery: 4S 2200mAH (tested) 65C or 6S racing drone type batteries
- 2x17g servos (PowerHD 1160A analogue used in prototype) + 2x common 9g flap servos, or 4 good quality 9g servos
- 60-80A ESC
-4x 6mm round neodym magnets
-low part count... 8 main pieces!
-carbon required: 1 piece 3x1mm flat strip (1m), 2x 100mmx 1mm rod or wire pieces for stabs
-pushrods: 0.8mm/ 0.032 music wire, 2x300mm
-hinges: CA type or Dubro micro will fit

https://www.youtube.com/watch?v=QmLxbpeidqA

Happy, well adhered enough printing!

LW-PLA Settings
- 2 walls of LW-PLA
- 2-3 bottom layers
- Parts are 200mm
- 0% infill except for fins (1%)
- Print orientation: Fuselage rear bulkheads on build plate (except for afterburner part)