4 Mangekyou sharingan (Sasuke, Itachi, Kakashi, Izuna, Shisui)

It is a keychain that is printed in 2 parts. the first part consists of the circle and the second part consists of the black blades. It should not be printed with supports either of the two parts, are made to be printed without the need for any support, but to look good should be printed at a relatively slow speed. then I will put the parameters you use.

To get the black blades inside the circle should be with light pressure, not too hard so it does not break.

Note: it is advisable to wait for the hot bed to cool down and then remove the blade part to avoid deformation, as it is a relatively thin part.

Sometimes it is advisable to sand the blades a little before putting it in the circle to eliminate imperfections and to allow it to rotate better.

Used machine: Artillery X1

-Circle

material used : PLA

Layer height: 0.32 mm

Filling density: 80% (to make the piece resistant)

Printing speed: 30 mm /s

Traverse speed: 30 mm/s

Fan speed: 50%

Printing temperature: 210 degrees

Base plate temperature: 60 degrees

No Stands

The part can be printed without the need for supports

-black wasps

material used : PLA

layer height: 0.2 mm

Filling density: 80%

Print speed: 20 mm /s

Traverse speed: 20 mm/s

Fan speed: 50%

Printing temperature: 210 degrees

Base plate temperature: 60 degrees

Key ring dimensions

circle:

X: 4.02 cm

Y: 4.54 cm

Z: 0.49 cm