emoji cam cover
Not the most simple print but designed to print in parts and then print as an inlay print.
this is printed on a creality with a .35 nozzle and layer height 0.2 with pla filament off the label by ctrl design
nozzle temp is 210 and bed temp is 62
Please make sure that al the prints are centered in your clicer.
print the parts of the emoji except the red parts.
print the devil red part 1
stay with the printer so you can turn back on the heated bed when the print is done.
do not remove the print from the bed but take the other parts of the emoji and place them in the print.
this is the tricky part.
Make sure that you place this file (devil part2) 1mm above the z 0. then run it trough the clicer and check if its 1 mm higher than the bed level 0. If you do not do this the nozzle will destroy the print.
If you do this right you can now start the print and it will go over the print witch is still on your bed with all the inlay parts.
measure the thickness of your device and then print the right comb clip file.
good luck printing
this is a design you can print but not sell copyright is with by ctrl design
Owner of ctrl design interieurarchitectuur
Owner of By ctrl design
Printing with a Opiliones delta printer, Ender, creality cr10 300 and cr10 400
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!