Cute Frog - Cable, Phone & Magsafe Stand

Print-in-place
No Support Needed

I'm super excited to share with you the Cute Frog Cable Holder! 🐸

It's a print-in-place design, which means you don't need any support material or assembly. Just print it and enjoy!

The Cute Frog Cable Holder has two cable notches:

one is 3mm, and the other one is 4.5mm.

You can use them to organize your cables and keep them from tangling. The frog also has a cradle for your phone that measures 1.5cm by 8.4cm, which accommodates most phones with standard cases.

You can place the official Apple Wireless Charger inside the frog to wirelessly charge your iPhone or AirPods, for example.

Under the frog, there is a 3cm diameter placeholder to place an optional 2mm (and up) gel pad or double-sided pad.

The model features are already separated by colors. You can easily customize the frog's appearance by changing the filament colors or using different materials. There's no need for painting in the Slicer; use the fill option!

Make sure you do not have an elephant foot (the first layers squished too hard into the bed); otherwise, the hinge nor the Apple Wireless Charger placeholder will work.

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the platform of your liking:
🔵Thangs - www.thangs.com/designer/Holoprops (http://www.thangs.com/designer/Holoprops)
🟠Patreon - www.patreon.com/holoprops

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• No support is needed to print this frog. Everything is Print-in-Place.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid or Cubic

• Prepare and clean your bed for excellent adhesion.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing and bed temperatures are adequate for the filament you are about to use.