PENIS VALVE CAP (SCHRADER VALVE)

Want to customize your car or bike? Want to give your friends a naughty present? The penis cap is the zany accessory par excellence.

Designed for schrader valves, it can be fitted to a bike or car equipped with these valves.

It is 3cm high and 1.5cm wide at the balls.

I recommend using a sturdy plastic (PLA type) with low shrinkage to screw on the cap without difficulty.

Place the cap vertically for printing.

Do not change the scale of the model (unless you encounter a problem with the screw pitch during assembly, in which case slightly increase the overall scale of the model).

Filling: 18

Print speed: normal (if you notice any defects, reduce the speed)

Adhesion plate: YES (especially if you're printing the model in ABS or another material prone to warping)

Support : NO

Plastic required: 2 grams

Printing time: depends on your settings

For information I printed the cap in ABS and it mounts well on the valve but I don't recommend this material.