Print your own wallet!
Originally designed for semi-flexible filaments such as TPE (used for the red wallets in the photos).
The Mini is printable in stiffer materials (white PLA used in first photo). However, this gives a very tight fit for the cards so you might want to scale it up with a few percent. If printed in flexible materials such as TPE there is no need to scale, cards should fit perfectly as is.
Best for those of you who use cash a lot. It has 6 card slots and a bill compartment fitting bills up to 187x74mm without folding; if you use higher bills, just scale up the Z axis when printing - The card slots will still be usable thanks to the grip area made for easier card handling
Best for those who rarely use cash and/or want a wallet as small as possible.
It has 4 quick access card slots, each holding a single card. Additionally there is a middle slot that can fit 3 cards and/or emergency cash (folded). The middle slot is slighty deeper in relation to the top edges to protect bills and rarely-used cards.
There are two versions of each model:
Skull contains the skull logo from Quentin Tarantino's Death Proof (painted on the car driven by Kurt Russell).
Clean is completely plain, add your own logo, name or phone number as you wish.
I have used both the Full and Mini versions for a couple of week each, there are no signs of wear and tear so far. The contents stay in place and I never worry about dropping cards or bills by mistake. Both models go nicely in the pocket, especially the Mini.
Designed for 0.4mm nozzles, all walls are exactly 0.4mm wide. If your slicer can't render the walls properly, set your slicer to use a 0.39mm Extrusion Width and/or Nozzle Diameter. Make sure you preview the print to confirm this.
Also make sure you set your slicer to not use more than one wall, otherwise the slots will be too tight. The bottom of the model is 0.8mm, so you can use multiple solid bottom layers if you want.
Print SLOW, especially if you use a flexible filament. This goes for both print speed and X/Y travel speeds, as you don't want the print to wobble back and forth with such thin walls. Red wallets in photos were printed at 40mm/s, but I would go even slower next time.
Using a brim helps circumventing the wobble a bit, 10 rounds are plenty.
High layer resolution is only needed if you use the non-clean versions and you want the outside details to be perfectly smooth.
Hi! I'm a tinkerer, designer and maker from Sweden. If you like my designs, feel free to leave a comment. :)
You like Cults and you want to help us continue the adventure independently? Please note that we are a small team of 3 people, therefore it is very simple to support us to maintain the activity and create future developments. Here are 4 solutions accessible to all:
ADVERTISING: Disable your AdBlock banner blocker and click on our banner ads.
DONATE: If you want, you can make a donation via PayPal here.
WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!