Emoji Snap Badge Set

Snap Badges! The front and the back snap together with fabric in between to make a fun, eye-catching badge. They work on shirts, skirts, ribbons, lanyards, and more as long as the fabric is not too thick. Or print only the tops and make them into magnets. Smiles guaranteed!

Great for party favors, stocking stuffers, promoting school spirit, advertising, or a special event.

This was a fun summer project in 2019. My daughter's character in her summer program performance was the Wink Emoji and she encouraged me to make all of the characters in her play.

I included model files for the back, the top, and the images for the top. See recommendations in the 3D Printing Settings. These may be printed with single or multiple extrusion.

For detailed photos of each of the Emoji Snap Badges, see:
• Wink Emoji Snap Badge
• Cool Emoji Snap Badge
• Eye Roll Emoji Snap Badge
• Angel Emoji Snap Badge
• Crying Laughing Emoji Snap Badge
• Poop Emoji Snap Badge
• Devil Emoji Snap Badge

Full Collection of All Snap Badges

See them all: Snap Badges Collection
Emoji's, Holidays, Halloween, and more. Exclusively on Cults!

Directions

Not recommended for delicate fabrics or putting over a decal on a shirt. The backing goes behind the fabric (inside a shirt, for example) and the top part snaps into the back gripping the fabric between the pieces. To remove, grip the edges of the top piece with the image and place your thumbs inside the circle of the backing. Press with your thumbs to pop off the top while pulling back on the edges of the backing at the same time. It usually works best if all of the force is focused toward one edge of the badge. If one direction seems tough, shift slightly toward a different edge of the badge.

For magnets, adhesive 20 mm round, 2mm thick work well and you don’t need to print the backs.

No remixes or derivatives. I would consider making custom designs such as for a school, a team, a company, or an event. Please use the On Demand tab on the Cults web site for requests.

Inspired by pop badges from Legoland California.

Back: 51 x 51 x 7 mm approximately
Top: 47 x 47 x 5 mm approximately
Emoji Images: 1.5 mm thick

The Back and the Top may be printed with the same settings. I used 0.2 mm layer height, 20% infill, 3 top layers, 3 bottom layers, 2 outline/perimeter shells. No raft. The back does not need supports. I was able to print the top with and without supports for the indentation in the middle. I prefer the smoother surface printed with short supports.

Do not print the top inside the back. They print well in the same print job but are separate.