Storage cube for SD and MicroSD cards. 12 SD / 8 MICROSD OR 4 SD / 40 MICROSD

Storage box for 12 SD cards and 8 MicroSD cards.

If you knew the cube for Nintendo Switch cartridges (https://cults3d.com/en/3d-model/game/cube-de-rangement-pour-cartouches-de-jeux-nintendo-switch ), here is the version for SD and MicroSD cards.
It is a small cube that fits in the hand (5.1 cm) and which can store 12 SD cards and 8 MicroSD cards. When you open it, you can see all your cards at a glance, and you can insert and remove them without any effort and without any click. Your cards are perfectly maintained and do not risk being damaged during handling. Finally, its appearance is unique. You can display it proudly on your desk, no need to put it in a drawer.
There are two models available. A smooth, basic. And one with a surface texture.

IMPORTANT: The files you buy are sold under Copyright. This means that they cannot be sold or distributed for free. Additionally, you may not sell prints made from these files. If you did, you would jeopardize the creation of new designs. Thank you for your understanding.
YOU CAN HOWEVER SELL YOUR PRINTS OF MY DESIGNS by subscribing to the "3D print seller" subscription: https://www.patreon.com/LabLabStudio
ALL MY DESIGNS ARE INCLUDED IN THIS SUBSCRIPTION

Assembly guide here (this is for the Switch cartridge version but the principle is the same) : https://youtu.be/1p5rXxDVKFE

You will find all the instructions in Guide-en.pdf.

For a cubic cow version of this cube : https://cults3d.com/en/3d-model/gadget/storage-cow-for-sd-and-microsd-cards-12-sd-8-microsd-or-4-sd-40-microsd

For a Nintendo Switch games version : https://cults3d.com/en/3d-model/fashion/cube-de-rangement-pour-cartouches-de-jeux-nintendo-switch

NEW: 3 new files allow you to store up to 32 MicroSD cards in the internal chain.

Layer height: 0.2 mm (it is certainly possible to make thinner)
Material: PLA (tested), PETG (tested), ABS (probably possible, not tested). DON'T TRY WITH RESIN, IT WON'T WORK.
Printing time: 9h30 - 10h00
Length: 21.5 m
Weight: 64 g

8 - First Link*.stl must be printed with supports.

For the temperatures and printing speeds, you can use the parameters that you master, depending on your printer and your filament.

This object is articulated and requires a high level of precision. Adherence to the build plate is therefore essential. The slightest deformation due to warping would compromise the correct opening and closing of the box. I advise you to use glue or lacquer to improve the adherence.