wine glasses wall art wine glass wall decor 2d kitchen decoration

A set of two different wine glasses in one file.

SECURE SELLING RIGHTS AND UNLOCK UNLIMITED ACCESS TO ALL MY FILES BY SUBSCRIBING BELOW 🔓🗄️🤝

https://www.kaozstudios.com/memberships/

My settings are based primarily for use on Prusa Slicer with our Prusa MK3S machines, however I tried to make an average variance in this section to fit most printers. As follows: .4 nozzle, PLA , 215C. 15% to 20% Infill. For variation in detail of negative space (thinner lines), you can use anywhere from -0.1 to -0.5 on XY., and for additional fill (make your lines thicker) do the opposite , usually +0.1 to +0.5. On our Bambu Labs Printers (Bambu Studio) I'll adjust both the xy hole and xy contour with the same values and then 3mm to 4mm standard on Z for either. Adjust to fit the properties best suited for YOUR printer/ slicer set up. Size your file accordingly to your build plate. Some files may have multiple parts as shown in the pictures, and each can be printed out seperately if desired by cropping directly in your slicer, or by adding a negative space (hole) with the print part you want to keep (solid) and combining the two in your modeling program.

💝 Upon subscription, you'll immediately gain unrestricted access to all my files, past present and future, allowing you to fully indulge in your creative pursuits. Plus, enjoy the exclusive privilege to sell your crafted creations based on my designs, anytime, anywhere for as long as you remain subscribed.

⚠️ You MUST maintain your subscription to sell your creations using my files. No exceptions.

Remixing any of my files is strictly prohibited without being subscribed to the above link. Resale of any file that originated from my work is never allowed at any time. Thanks bunches for complying 😉 !