Small Maracas Embossed Pattern Semi-Traditional

Just a simple small maraca. The bell is 60mm (2.3") in diameter and 85mm(3.3") long. The handle is 30mm (1.1") at the widest, 12mm (~0.45")at the narrowest and 90mm (3.5") long.

The joining screw is standard 10mm coarse threaded. And that leaves an 8mm fill hole in the bell. You can of course put anything inside you'd like to use, but I've included printable 'rice' type beads and truncated 6mm cube type beads to create a customizable sound.

The open hole design of course means you should not give this to small children as they may find a way to dislodge the small parts inside! Even if the parts are glued together, heavy caution should be used. I cannot be held liable for any misuse, you have been notified. :p

The maracas in the photo were printed with Lodesign wood filament. Fully stain-able and paint-able.
0.15mm layer height
212C/61C temps
~55mm/s speeds

The bell and handle are both meant to be printed with the threaded joint on the print bed. No supports required.