Sculpture made with Zbrush, it is printed in one part only.
Printing does not require any support, but a raft is recommended.
I made this impression in just over 38 hours,.
For the finish, after deburring and sanding I applied 2 coats of filling resin
Height: about 13.5 cm
I made a video of the printing (it doesn't last 38 hours!) you can see it on Youtube :
The Octopus license is for personal, non-commercial use only.
Anycube l3 mega printer
PLA 1.75 printing (3D neofil filament 3D silver)
print quality 0.1
wall thickness 0.8
20% filling density 20% filling density
printing temperature 200
temp bed 60
Vous pouvez suivre mes projets en cours et mes autres travaux sur Instagram : https://www.instagram.com/arty_smod/?hl=fr
Page translated by automatic translation. Suggest a better translation