HARRY POTTER WAND

​This is my Harry Potter Wand design.

Inspired from Harry Potter!

This model made by me!
Modelling time 2 hours!
It is high-resolution model. About 180.000 polygons.
Two part. But full wand (without split) is included.
Made in cinema 4D.
NO SUPPORT! JUST PRINT!
This wand is two part. You need to glue them after print.
If you print 100 micron (0.1mm), you won't need sandpaper! :)

CREALITY CR-10 PRINT SETTINGS

100micron (0.1mm) Layer height
%60 infill
NO SUPPORT
60 degrees Bed heat
200 degrees Nozzle heat

7 hours print time!

I hope you like guys!

You can follow my Instagram pages!
@tolgaaxu
@buyucusokagi

If you have any question about my designs or anything, please do not hesitate to write me a message!
See you on next projects!

Harry Potter's wand was 11" long, made of holly, and possessed a phoenix feather core.
This was described by Garrick Ollivander to be an unusual combination of wand core and wood.
The feather was donated by Fawkes, Albus Dumbledore's phoenix. It was revealed by
Garrick Ollivander that Tom Riddle's wand core also came from Fawkes, making the
two wands "brothers". Harry's wand was described as being "nice and supple"

Taken from harrypotter.wikia.com

100micron (0.1mm) Layer height
%60 infill
NO SUPPORT
60 degrees Bed heat
200 degrees Nozzle heat

7 hours print time!