Female torso (voronoi)

Female Torso remixed from model:

https://www.thingiverse.com/thing:146403

Credit goes out to: CosmoWenman; who captured this piece in the 1st place.

Dimensions of the model are: 95*70*170mm. I have printed this model in 7 hours and 42 minutes with a 0.25mm resolution.

I have made a few changes to the original model. But after three failed models and prints I finally succeeded. As you can see I made a voronoi pattern to the torso. I also scaled up the breasts of the torso and replaced the base. This is a strong model, even printed in PLA I'm amazed how sturdily the print is.

Print this model in your favourite color and material. If you have printed the model you can choose if you would like to upload a picture of your make. I would really love that!

You can also have a look at my personal website:

https://www.raimoncoding.nl/

  -or-

https://www.raimoncoding.com/

Made with love by:

Raimon of IdeaLab

Note! I have used a raft for this print, just to be sure the model would print right. I have printed this model in Fillamentum turquoise green PLA. And have used a 0.25mm layer height. My recommended printspeed is 60mm/s for this model. And i have used 18% infill. I was printing with a 0.4mm nozzle on 210 degrees Celcius. I have used Cura for slicing.