This is a cool DIY lamp project.
If you want to enlight it, you need a switch(as in the pictures), cables, LEDs, resistors and a 9V battery.
The LED's are put through the holes at the end of the top part and connected via the switch with the battery. I took here a Voltage converter to control the LED's, and I used colour change LED's
You need every part and to assmble it like in the picture. The Top and bottom wil side perfectly over each other(maybe you have to sand it a little bit.)
The bowls areglued with superglue to th ends of the stems and then hold also the led's in place. You miht have to use a dremel for a hole in the flat side of the balls
Only at the base
pay attention to a good bed adheasion
The bowls have a flat are, print this to the printbed
Main site: (feel free to click around in my designs (: )
On this site, I will in future sell in additrion to my normal designs some better ones!