Skip to content
STL files Christmas house scene, johnkindon1
STL files Christmas house scene, johnkindon1

Did you 3D print this model?

Christmas house scene

3D model description

house garage snowman sleigh and one reindeer and Santa plus Santa on roof with present bag can be illuminated the house garage snowman tree entrance porch snowman takes about 88 metres and 27 hours to print can be enlarged or shrunk up to you it is hollowed out channelled for wiring up to you if you wish to add more to the scene hope you like took 120 plus hours to create this is my first one i have put online for others to use .please note dont print at a 100% print at 150% and above it was to small to show detail so print at 130% to 150% or bigger bigger the better the more detail will show please enjoy i did print at a 100% there was not much detail as it was way to small to show but 130 and above will show detail the best will be 150 and above .

3D printing settings

i have printed in standard form on a creality s10 i has bed temp at 75 c i used support everywhere
printed at 150%
layer height 0.2
initial layer height 0.2
line width 0.4
wall line width 0.4
top/bottom line width 0.4
infill line width 0.4
skirt/brim line width 0.4
wall thickness 0.8
wall line count 2
z seam alignment sharpest corner
infill 20%
infill steps 0
print temperature 200c
print bed temp 75c
print speed 60 mms
enable print cooling
time of standard size print is 27 hours 36 mins
material used PLA 88.66 metres.
build plate adhesion skirt

  • 3D model format: STL





Similar 3D files

Best sellers of the category Architecture

Add a comment