Proto Bong

Stylish bong with Tri Pull Matrix produces a smoother hit.

Draws like a pencil, hits like a Bong!

Requires a 14mm bowl

I used .25 layer height for all parts but of course you can print @ a higher resolution if you wish

Retraction settings:

• Only retract when crossing open spaces
• Minimum Travel for retraction 6mm
• Perform retraction during wipe

I did not use 'Avoid crossing outline for travel movements' as this for some reason doesn't print as well especially along the start line/seam.

Select 'Choose start point closest to specific location' and rotate parts in your slicer until seam is down the back of the part(s)

I used supports only for the Connector.stl as there is an inside rim, you may have good results without supports with your printer, it's a small piece so I would try without supports first.

I find the bowl will leak eventually if it is not coated on the inside

To coat the bowl:

• Varathane Diamond Wood Finish - Interior Water based poly - I think I paid $9.00 CDN

  • For Food Safe, BPA free, 0 VOC you can use a product called Art Resin it's a tad more expensive to purchase.

Assembly:

Sand with 300 grit sandpaper just to rough up the contact points and use non toxic glue, I used Weldbond Adhesive, 420-mL.

Sand the inside of the bowl as well before applying Coating

Tips: paypal.me/GamerDesk