martinezrx7
any supports involved in this ring design ? thank you .
- 0 Likes
Achtung, liebe Freunde, es handelt sich nicht um einen privaten Nachrichtendienst, sondern um einen öffentlichen Diskussionsthread. Dies ist ein Ort des Austausches. Bitte bleibt höflich und respektvoll. Jegliche kommerziellen oder gehässigen Beiträge werden gelöscht. Wenn Sie ein bestimmtes Design erwähnen, fügen Sie bitte den Link oder den Titel des Designs in Ihrer Nachricht hinzu, damit die Konversation richtig geleitet werden kann. Wenn Sie Ihrem Beitrag Fotos beifügen möchten, können Sie Ihre Bilder bei einem kostenlosen Online-Bilder-Hosting-Dienst wie Imgbb hochladen und die Links zu den Bildern in Ihren Kommentar kopieren/einfügen. Viel Spaß beim Diskutieren!
Schreibe deine Nachricht:
5 Kommentare
martinezrx7
The Gastropnir, Primal Male Ring & and the Modern Ring require supports. The Primal Female ring can print with no supports but will get best results with supports.
- 0 Likes
Hi Patmerry, I carefully sanded the model with 120 sand paper to get "grain" direction and in the case of the primal female ring, I used a sand blazer to etch the metal pattern into it. As for colour I use Tempera Powder paints with a sponge brush the get the correct finish.
- 0 Likes
Hi there, I love your designs. How did you get that metal looking finish? It'd be awesome to be able to get the same finish. Thanks. Matt
- 0 Likes
Hi Patmerry, I carefully sanded the model with 120 sand paper to get "grain" direction and in the case of the primal female ring, I used a sand blazer to etch the metal pattern into it. As for colour I use Tempera Powder paints with a sponge brush the get the correct finish.
- 0 Likes
Hi Lucas, I'm terribly sorry for the late reply but to answer your question I use black ABS filament from XYZ printing with a layer height of 0.12mm. After print, I give each ring a quick smooth over with 80 grit sandpaper then finish it off with 120 sandpaper. This gives it a more rugged look and feel. For more elegant prints I use a homemade acetone bath to give a print a clean and shiny appearance.
- 0 Likes
Hi, I'm Lucas. I really liked your rings and the photos are incredible. I would like to know what material you used to print them and the layer height.
- 0 Likes