Zum Inhalt gehen

Xenos Hater Handgelenk-Teil

Qualität des Makes: 0,0/5 (0 Stimmen)
Bewertung von Mitgliedern zur Qualität des 3D-Drucks, der Nachbearbeitung, des Fotos usw.

Beschreibung des Makes

The Wrist-Piece really helps to give my all-new Primaris Librarian Watch Master (you can never have too many titles, right?) the right feel.
I slightly modified it while mesh-bashing in Meshmixer to accommodate the shoulder pad (removed the elbow thingy). The pointy bits are quite delicate, but printable if supported correctly (i.e. many but quite thin supports). I unfortunately do not remember the scaling factor, I just tried until it look right.

  • Auflösung: 0,05 mm
  • Support: Ja

Kommentar hinzufügen

Ein Kommentar