Zum Inhalt gehen

The Nightmare Before Christmas - Diorama

?
Qualität des Makes: 0,0/5 (0 Stimmen)
Bewertung von Mitgliedern zur Qualität des 3D-Drucks, der Nachbearbeitung, des Fotos usw.
  • 1 Like
Macher
3D-Datei

Beschreibung des Makes

I needed up concerting this scene into a lid for a jewelry box for a friends birthday gift. Looks pretty good I have to say! It’s scaled down to 60% and I added a block to the bottom to keep it on the box I designed.
The lid took about 5 hours and all told the print took about 14 hours though it might be less then that if I didn’t have a few print failures. I honestly don’t think I would have had so much trouble if I had kept it the full size. But couldn’t fit that on the build plate so...
Note the part I had trouble with was the curl which is separate. It’s just a difficult shape to support even separated from the full scene. I also tried to add jack skellington but he was just to delicate with the setting I was using. I also kept the moon off so I could print that in a different color.
The infill number is not right cause I hollowed it using chitchu box and I don’t know what % that would be for resin printing. Same for the temp

  • Raft: Nein
  • Auflösung: 0,05 mm
  • Temperatur: 100 ℃
  • Support: Nein
  • Infill: 10 %
  • Geschwindigkeit 55 mm/s

Kommentar hinzufügen