Skip to content

Anal tunnel

3D model description

The idea was initially to test the possibility of making a plug with an opening. It turns out that it works not too bad to print. A test you :)

3D printing settings

55 mm high
35 mm wide (the biggest)
28 mm wide (at least roughly)
20mm wide (center)

Printing ABS, light sanding and finish with acetone. The record is more slippery. Clean with soap after treatment.

0.1 mm on Z
50 mm / s in advance
24% of filler
Nozzle to 235 ° C
Plate at 100 ° C
No support, easy printing from the large base

Creator

Share

Copyright

Similar creations


Add a comment