uneri-U has the image of a curve depicting the U is the image seen from the side in the display base that can be placed accessories, pens, watches, bits and bobs.
(It depends on the kind of watch and accessories.)
Easy Kimekomi by outputting a 3D printer!
(full cover Kimekomi Body)
It has become a model of support basically unnecessary.
It has become a model that assumes the output at a 3d printer fdm method.
There is a case where the output can be difficult depending on the type of slicer and 3d printer.
The output product by direct, indirect damages can not be held responsible in any case.
Image of 1-3 piece is in condition to have a Kimekomi.
Image of the fourth piece is the shading data state.
Accessories in the image is not attached.
Please refer to this http://3dpblog.studiorevent.com/?eid=2 material, tool, work in regard to the steps required Kimekomi.
I have been creating works using a 3D printer.
I have created a work that combines Kimekomi method which is used in the traditional crafts of Japan.