Here is a small office to furnish your models.
TO NOTE :
You will need to cut a rectangle of 12 mm by 8 mm in a small wooden board to make the drawer. Personally I created the drawer with balsa because it is a soft wood so easier to cut.
Do not hesitate to post your "Make", it would please me.
Printed with Discovery 200 from Dagoma
Printing parameters made with: "Cura By Dagoma"
Temperature: 200 ° c
Filling: Hollow (hull)
Quality (layer thickness): Fast (0.20mm)
Print Area: Buildatk
Filament used: PLA Filo 3D White
Printing time: 18 minutes
Filament cost: 1.52 meters or 5 grams