Skip to content

2017 by E creator

3D model description

2017 is fast approaching! For that, download and print these small 2017 to decorate your table of the new year (as I will do) to offer as gift or as decoration To make pictures like the ones I made! If you find other nice ideas of use of this object do not hesitate to communicate it in the commentaries!

  On that, I wish all the Maker a very good year 2017, and hope that all your future impressions will be superb!

3D printing settings

3D Printer used: Discovery200 from Dagoma
Print setup software used: Cura by Dagoma Filament used: PLA Octofiber White 1.75mm
Nozzle temperature: 200 ° C
Filling: hollow
Print Quality: Fast (0.20mm Accuracy)
Print Area: Buildtak
Printing time: 10 minutes
Amount of filament used: 0.68 meters ie 2 grams
Cost of printing (excluding electricity): Approximately 8 cents

NOTE: It is not necessary to improve the surface of adhesion because it is too difficult to remove!

  • 3D model format: STL



Créateur Français d'objets à imprimer.




Similar creations

Add a comment