Skip to content

Tyrion Lannister (Peter Dinklage)

3D model description

This is my model of tyrion lannister, it was printed in pla at .1mm layer height with a .3mm nozzle. the culpting of the series of models based on "the binding of isaac" were paused while i was finishing tyrion

Note that you will have to glue all pieces together xD, since the cup is so little and the only contact point are his fingers, it was obvious that i was gonna have to use glue to hold it in place ( without glue, it stays in place if you dont move the figurine though), and as i was already gonna use glue well...didnt bother to make the arm press fit pin

hope you like it, and if you want to support me and my models, you could consider tipping me, on my myminifactory account =D (prozer), i would really appreciate, the model is not there yet, but i'll be uploading it there too, thanks!

3D printing settings

it was printed in pla at .1mm layer height with a .3mm nozzle

  • 3D model format: STL

Tags

Creator

digital sculptor of super sculpting bros

Share

License

CC BY NC ND

Similar creations


Add a comment