Skip to content

Turnip Head!

3D model description

Turnip Head, from the wonderful movie Howl's Moving Castle. If you have not seen it, I highly recommend you do so. The model is an easy enough print with no supports needed.

I've set it up for two print beds. One measures 170.03 x 88.04 x 93.16. The second measures 79.95 x 91.48 x 98.05.

I've also included the full model and the parts.

The model measure around 30 cm tall when assembled. Reduce at your own risk:P

3D printing settings

Printer:
Prusa i3 mk2

Rafts:
No

Supports:
No

Resolution:
.15

Infill:
20%

Arms and pipe
I used a bit of heat to soften the arm joint before gluing them together.

I've taken his pipe and put it inside of his hat. It should just snap off. I had no problem printing it but it is really, really small. I've included a small hole in Turnip Heads left side mouth for placement.

The only areas that required a bit of sanding was his chin and the bow-tie.

Creator

Share

License

CC BY NC

Similar creations


Add a comment