Skip to content

Hunter Skull HD (with supports)

3D model description

I intend to print this out in very high resolution and found the original mesh was a little jagged in places, especially the teeth and eye sockets (original vs new mesh in thumbnails..).

I increased the subdivision on it from about 260,000 poly's to 3,000,000 polys, sculpted some details back in, smoothed as much as I could without going blind, flattened it and centered it, scaled it to 10cm height then cut it back from 388mb to about 30mb, which sliced in no time at all.

After reading some of the comments from people that have printed them before, and seeing it can be done without supports. I did a couple of test prints and added supports where needed, the chin will stay stuck, there is supports for under the back of the skull and most importantly the cheeks which really needed it.

This should look fairly good when printed with an SLA printer I would imagine, there is alot of detail in it, thanks for the original Syfy.

3D printing settings

Printer:
Kossel Mini

Rafts:
Yes

Supports:
No

Resolution:
0.15-0.2

Infill:
5%-10%

Tags

Creator

I love Cats, guitars and Starwars.

And pancakes. Everyone loves pancakes.

I can be contacted for custom design work at geoff@hex3d.com

I also have some designs that are not here available to my patreon members
https://www.patreon.com/Geoffro

Share

License

CC BY

Similar creations


Add a comment